STTS751

Active
Design Win

2.25 V low-voltage local digital temperature sensor

Download datasheet Order Direct
Overview
Sample & Buy
Solutions
Documentation
CAD Resources
Tools & Software
Quality & Reliability
Get Started
Partner products
Sales Briefcase

Product overview

Description

The STTS751 is a digital temperature sensor which communicates over a 2-wire SMBus 2.0 compatible bus. The temperature is measured with a user-configurable resolution between 9 and 12 bits. At 9 bits, the smallest step size is 0.5 °C, and at 12 bits, it is 0.0625 °C. At the default resolution (10 bits, 0.25 °C/LSB), the conversion time is nominally 21 milliseconds.

The open-drain EVENT output is used to indicate an alarm condition in which the measured temperature has exceeded the user-programmed high limit or fallen below the low limit. When the EVENT pin is asserted, the host can respond using the SMBus Alert Response Address (ARA) protocol to which the STTS751 will respond by sending its slave address.

The STTS751 is a 6-pin device that supports user-configurable slave addresses. Via the pull-up resistor on the Addr/Therm pin, one of four different slave addresses can be specified. Two order numbers (STTS751-0 and STTS751-1) provide two different sets of slave addresses bringing the total available to eight. Thus, up to eight devices can share the same 2-wire SMBus without ambiguity, thereby allowing monitoring of multiple temperature zones in an application.

The two-wire interface can support transfer rates up to 400 kHz.

  • All features

    • Operating voltage 2.25 V to 3.6 V
    • Operating temperature –40 °C to +125 °C
    • Programmable
      • 10 different conversion rates 0.0625 to 32 conversions/sec. 1 conversion/sec. - default
      • 4 different resolutions 9-bit (0.5 °C/LSB) to12-bit (0.0625 °C/LSB) 10-bit (0.25 °C/LSB) - default
    • Low supply current
      • 50 μA (typ) for 8 conversions/sec.
      • 20 μA (typ) for 1 conversion/sec.
      • 3 μA (typ) standby
    • Accuracy
      • ±0.5 °C (typ) 0 °C to +85 °C
      • ±0.5 °C (typ) –40 °C to +125 °C
    • One-shot mode for power saving
    • Fast conversion time 21 ms (typ) 10-bit
    • Pull-up resistor value allows single pin to select one of four slave addresses
    • Supports 400 kHz serial clock
    • SMBus 2.0 compatible
      • SMBus ALERT (ARA) support
      • SMBus timeout
    • RoHS/green

You might also like...

All tools & software

    • Part number
      Status
      Description
      Type
      Supplier

      SensiBLE

      Active

      Certified Bluetooth low energy master/slave network processor module, compliant with Bluetooth v4.1

      Hardware Integrated Devices from Partners SensiEDGE
      SensiBLE

      Description:

      Certified Bluetooth low energy master/slave network processor module, compliant with Bluetooth v4.1

      SensiBLE 2.0

      Active

      Low power single core (SOC) system-on-chip with 32MHz 32-bit ARM® Cortex®-M0 CPU, and Certified Bluetooth low energy (BLE) v4.2

      Hardware Integrated Devices from Partners SensiEDGE
      SensiBLE 2.0

      Description:

      Low power single core (SOC) system-on-chip with 32MHz 32-bit ARM® Cortex®-M0 CPU, and Certified Bluetooth low energy (BLE) v4.2

      SensiBLE 2.1

      Active

      Low power single core (SOC) system-on-chip with 32MHz 32-bit ARM® Cortex®-M0 MCU, Certified Bluetooth low energy (BLE) v5.2

      Hardware Integrated Devices from Partners SensiEDGE
      SensiBLE 2.1

      Description:

      Low power single core (SOC) system-on-chip with 32MHz 32-bit ARM® Cortex®-M0 MCU, Certified Bluetooth low energy (BLE) v5.2

      SensiSUB

      Active

      End-to-end solution for LPWAN enabling cloud connectivity to sensor data over a long range Sub-1 GHz star network

      Hardware Integrated Devices from Partners SensiEDGE
      SensiSUB

      Description:

      End-to-end solution for LPWAN enabling cloud connectivity to sensor data over a long range Sub-1 GHz star network
    • Part number
      Status
      Description
      Type
      Supplier

      AndroidHALInput

      Active

      Android sensor HAL for MEMS motion and environmental sensors (Input framework)

      Drivers for MEMS ST
      AndroidHALInput

      Description:

      Android sensor HAL for MEMS motion and environmental sensors (Input framework)

      C-Driver-MEMS

      Active

      Standard C platform-independent drivers for MEMS motion and environmental sensors

      Drivers for MEMS ST
      C-Driver-MEMS

      Description:

      Standard C platform-independent drivers for MEMS motion and environmental sensors

      LinuxDriverInput

      Active

      Linux device drivers for MEMS motion and environmental sensors (Input framework)

      Drivers for MEMS ST
      LinuxDriverInput

      Description:

      Linux device drivers for MEMS motion and environmental sensors (Input framework)
    • Part number
      Status
      Description
      Type
      Supplier

      STEVAL-MKI198V1K

      Active

      Temperature probe kit based on STTS751

      MEMS Motion Sensor Eval Boards ST
      STEVAL-MKI198V1K

      Description:

      Temperature probe kit based on STTS751
    • Part number
      Status
      Description
      Type
      Supplier

      FAE Engineering Services

      Active

      Engineering services on the SensorTile.box surch as Plastic housing, HW and SW/App customizations and boards Manufacturing.

      Design Services from Partners FAE Technology
      FAE Engineering Services

      Description:

      Engineering services on the SensorTile.box surch as Plastic housing, HW and SW/App customizations and boards Manufacturing.

      SensiEDGE customization services

      Active

      End-to-end development services: Hardware, Firmware, Software development, Enclosure, Cloud and mobile APPs. Speed up your IoT project with SensiEDGE!

      Design Services from Partners SensiEDGE
      SensiEDGE customization services

      Description:

      End-to-end development services: Hardware, Firmware, Software development, Enclosure, Cloud and mobile APPs. Speed up your IoT project with SensiEDGE!
    • Part number
      Status
      Description
      Type
      Supplier

      STDES-FANPRE01

      Active

      Solution to enable predictive maintenance for fan and small motor applications, and condition based monitoring

      Sensor Solution Eval Boards ST
      STDES-FANPRE01

      Description:

      Solution to enable predictive maintenance for fan and small motor applications, and condition based monitoring
    • Part number
      Status
      Description
      Type
      Supplier

      X-NUCLEO-IKS01A3

      Active

      Motion MEMS and environmental sensor expansion board for STM32 Nucleo

      STM32 ODE Sense HW ST
      X-NUCLEO-IKS01A3

      Description:

      Motion MEMS and environmental sensor expansion board for STM32 Nucleo

EDA Symbols, Footprints and 3D Models

STMicroelectronics - STTS751

Speed up your design by downloading all the EDA symbols, footprints and 3D models for your application. You have access to a large number of CAD formats to fit with your design toolchain.

Symbols

Symbols

Footprints

Footprints

3D model

3D models

Quality and Reliability

Part Number Marketing Status Package RoHS Compliance Grade Material Declaration**
STTS751-0DP3F
Active
DFN6 2X2X0.5 Ecopack2
STTS751-1DP3F
Active
DFN6 2X2X0.5 Ecopack2

STTS751-0DP3F

Package:

DFN6 2X2X0.5

Material Declaration**:

PDF XML

Marketing Status

Active

Package

DFN6 2X2X0.5

RoHS Compliance Grade

Ecopack2

STTS751-1DP3F

Package:

DFN6 2X2X0.5

Material Declaration**:

PDF XML

Marketing Status

Active

Package

DFN6 2X2X0.5

RoHS Compliance Grade

Ecopack2

(**) The Material Declaration forms available on st.com may be generic documents based on the most commonly used package within a package family. For this reason, they may not be 100% accurate for a specific device. Please contact our sales support for information on specific devices.

Sample & Buy

Swipe or click the button to explore more details Don't show this again
Part Number
Order from distributors
Order from ST
Marketing Status
ECCN (US)
ECCN (EU)
Packing Type
Package
Temperature (°C) Country of Origin
Budgetary Price (US$)*/Qty
min
max
STTS751-0DP3F Available at distributors

Distributor availability of STTS751-0DP3F

Distributor Name
Region Stock Min. Order Third party link

Distributor reported inventory date:

No availability of distributors reported, please contact our sales office
Active
EAR99 NEC Tape and Reel DFN6 2X2X0.5 -40 125 THAILAND
STTS751-1DP3F Available at distributors

Distributor availability of STTS751-1DP3F

Distributor Name
Region Stock Min. Order Third party link

Distributor reported inventory date:

No availability of distributors reported, please contact our sales office
Active
EAR99 NEC Tape and Reel DFN6 2X2X0.5 -40 125 THAILAND

STTS751-0DP3F Active

Package:
DFN6 2X2X0.5
ECCN (US):
EAR99
Budgetary Price (US$)*/Qty:
-

Part Number:

STTS751-0DP3F

ECCN (EU):

NEC

Packing Type:

Tape and Reel

Operating Temperature (°C)

Min:

-40

Max:

125

Country of Origin:

THAILAND

Distributor Name

Distributor reported inventory date:

STTS751-1DP3F Active

Package:
DFN6 2X2X0.5
ECCN (US):
EAR99
Budgetary Price (US$)*/Qty:
-

Part Number:

STTS751-1DP3F

ECCN (EU):

NEC

Packing Type:

Tape and Reel

Operating Temperature (°C)

Min:

-40

Max:

125

Country of Origin:

THAILAND

Distributor Name

Distributor reported inventory date:

Swipe or click the button to explore more details Don't show this again

(*) Suggested Resale Price (USD) per defined quantity for BUDGETARY USE ONLY. For quotes, prices in local currency, please contact your local ST Sales Office or our Distributors