-
This board provides you an easy way to connect STMicroelectronics® VIPower® M0-7 technology into your existing system.
主要特性
- Simple single IC application board dedicated for VN7040AJ-E
- Provides electrical connectivity and thermal heat-sinking for easy prototyping
- General device features
- Single channel smart high-side driver with MultiSense analog feedback
- Very low standby current
- Compatible with 3 V and 5 V CMOS outputs
- MultiSense diagnostic functions
- Multiplexed analog feedback of: load current with high precision proportional current mirror, VCC supply voltage and TCHIP device temperature
- Overload and short to ground (power limitation) indication
- Thermal shutdown indication
- OFF-state open-load detection
- Output short to VCC detection
- Sense enable/disable
- Protections
- Undervoltage shutdown
- Overvoltage clamp
- Load current limitation
- Self limiting of fast thermal transients
- Configurable latch-off on overtemperature or power limitation with dedicated fault reset pin
- Loss of ground and loss of VCC
- Reverse battery with external components
- Electrostatic discharge protection
-
-
Build your ST evaluation High Side Driver Automotive system: thanks to the ST's SPC5-EV-ADIS adapter you can combine the SPC560B-DIS Discovery board along with VIPower easy boards addressing several automotive applications such as front & rear car lighting, automotive resistive, inductive and capacitive loads, automotive smart power distribution, glow plug, heating systems, relay replacement and high power resistive and inductive actuators.
A broad range of Easy Boards EV-VNx7xxx from 3mΩ to 140mΩ are available on ST.COM. Please find here below a complete list where to select the best boards fitting your application.
解决方案组件
产品型号 描述 状态 核心产品 价格 (US$)* 订购 / 下载全部购买SPC56B-Discovery 主要特性
- SPC560B54L5 32-bit 48 MHz e200z0h CPU, 32-bit Power Architecture® Technology CPU, 768 kB Code Flash in an LQFP144 package.
- On-board USB-JTAG PLS debugger and HW selection mode to use stand-alone JTAG debuggers.
- Board power supply: through external +12 V PSU or from the USB bus (5 V supply voltage).
- Seven LEDs: D6 for 5 V power on,D2 for Reset, D101, D102, D103 for PLS debugger section, D7 and D8 for PC3 and PC2 outputs
- Two push buttons (reset and user)
- A potentiometers for ADC input (user)
- Two extension headers (2 x 36 pin - 100 mil) for all LQFP144 pins and for quick connection to prototyping boards, additional modules and easy probing.
- JTAG interface (2 x 7 male 100mil connector)
- USB port (mini -B)
- 16 MHz crystal
- Specification:
- Board size 100 x 65 mm
- MCU: SPC560B54L5 - LQFP144
- 2 extension headers 2 x 36 pin - 100 mil
- DC connector (+12 V input)
- Mini USB - B
- JTAG 2 x 7 - 100 mil connector
Discovery Kit for SPC56 B line - with SPC560B54L5 MCU 批量生产85.75 立即购买 SPC5-EV-ADIS 主要特性
- Board size 100 x 55 mm
- Two extension headers (2 x 36 pin - 100 mil) for quick connection to SPC560B-DIS discovery board
- Extension headers for quick connection of M0-7 easy board
- Extension headers for quick connection of H-Bridge easy board
- Controllable by dedicated GUI for HSD or for H-Bridge available on www.st.com
- Free ready to run application firmware for HSD or for H-Bridge available on www.st.com, to support quick evaluation and development
Adapter board 批量生产32.12 立即购买 EV-VN7040AJ VN7040AJ evaluation board 批量生产VN7040AJTR 4.12 立即购买 STSW-SPC5EV-ADIS SPC5-EV-ADIS Graphical User Interface for M0-7 High Side Drivers 批量生产- 产品型号 供应商 下载 STSW-SPC5EV-ADIS ST STSW-SPC5EV-ADISDescription:
SPC5-EV-ADIS Graphical User Interface for M0-7 High Side Drivers价格 (US$)*
-产品型号 供应商 下载 STSW-SPC5EV-ADIS ST
-
| 产品型号 | 供货状态 | 符合RoHS级别 | WEEE Compliant | 材料声明** |
|---|---|---|---|---|
| EV-VN7040AJ | 批量生产 | Not compliant | - | |
EV-VN7040AJ
Package:
Not compliantMaterial Declaration**:
(**) st.com上提供的材料声明表单可能是基于包装系列中最常用的封装的通用文档。因此，它们可能不是100%适用于特定的设备。有关特定设备的信息，请联系 销售支持 。
