The STDS75 is a high-precision CMOS (digital) temperature sensor IC with a delta-sigma analog-to-digital (ADC) converter and an I2C-compatible serial digital interface. It is targeted for general applications such as personal computers, system thermal management, electronics equipment, and industrial controllers, and is packaged in the industry-standard 8-lead TSSOP package.
The device contains a bandgap temperature sensor and programmable 9- to 12-bit ADC which monitor and digitize the temperature to a resolution up to 0.0625 °C. The STDS75 is typically accurate to (±3 °C - max) over the full temperature measurement range of –55 °C to 125 °C with ±2 °C accuracy in the –25 °C to +100 °C range. At power-up, the STDS75 defaults to 9-bit resolution for software compatibility with the STLM75.
The STDS75 is specified for operating at supply voltages from 2.7 V to 5.5 V. Operating at 3.3 V, the supply current is typically (125 μA).
The onboard delta-sigma analog-to-digital converter (ADC) converts the measured temperature to a digital value that is calibrated in °C; for Fahrenheit applications a lookup table or conversion routine is required.
The STDS75 is factory-calibrated and requires no external components to measure temperature.
主要特性Measures temperatures from –55 °C to +125 °C (–67 °F to +257 °F)
- ±0.5 °C (typ) accuracy
- ±2 °C (max) accuracy from –25 °C to +100 °C
Low operating current: 125 μA (typ)
No external components required
2-wire I2C/SMBus-compatible serial interface
- Selectable serial bus address allows connection of up to eight devices on the same bus
Thermometer resolution is user-configurable from 9 (default) to 12 bits (0.5 °C to 0.0625 °C)
9-bit conversion time is 150 ms (max)
Programmable temperature threshold and hysteresis set pointsWide power supply range - operating voltage range: 2.7 V to 5.5 V
Pin- and software-compatible with DS75 (drop-in replacement)
Power-up defaults permit standalone operation as thermostat
Shutdown mode to minimize power consumption
Separate open drain output pin operates as an interrupt or comparator/thermostat output (dual purpose event pin)
MSOP8 (TSSOP8) package
Support and Applications
|型号||Marketing Status||Package||RoHS Compliance Grade||Material Declaration**|
(**) The Material Declaration forms available on st.com may be generic documents based on the most commonly used package within a package family. For this reason, they may not be 100% accurate for a specific device. Please contact our sales support for information on specific devices.