Registered on :
03-23-2007
From Spain
Messages : 2
 OFF-Line
|
I have started to work with PSDsoft Express, and i 'm doing the example in the AN 1560. All is right, but in the moment when i must do the C Code, i have problems, when I push the bottom "Generate C code, Specific to PSD". It appears to me a pop up with this message "Please check the website listed below for the latest firmware updates:" and two links. These links are:
http://mcu.st.com/mcu/modules.php?name=Content&pa=showpage&pid=55
http://mcu.st.com/mcu/modules.php?name=Content&pa=showpage&pid=56
What is the problem, and what is the solution?
I wish create a C code, but i don't understand if I must make the code with this option, or with Keil.
Thanks very much.
|
|
|
Problems with C Code Generation in PSDsoft Express
Posted 23-03-2007 at 12:37 
