芝刈り機

Key Features

• Universal input mains range:
  • input voltage: 90 VAC - 264 VAC
  • frequency: 45 Hz - 65 Hz
• Single-output voltage: 12 V @ 0.15 A continuous operation
• Standby mains consumption: < 50 mW @ 265 VAC
• Average efficiency: > 75%
• Fully protected against faults (overload, feedback disconnection and overheating)
• EMI: in accordance with EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• STEVAL-CTM004V1 (power board)
  • insulated metal substrate (IMS)
  • hosts 36 STH310N10F7 or STH315N10F7 power MOSFETs in the H²PAK-6 (6x switch) package
  • Decoupling gate resistors (2.2 Ω)
  • 3-shunt resistors ground referred for current sensing (optional)
  • 3 NTCs for thermal protection
• STEVAL-CTM005V1 (bulk capacitor board)
  • 22x 270 μF, 100 V through-hole aluminium electrolytic capacitor
• STEVAL-CTM006V1 (driver board)
  • based on 3x L6491 gate driver with current capability up to 4 A sink/source
  • 34-pin MC connector
  • overcurrent, overtemperature and overvoltage protection
• STEVAL-CTM008V1 (current sensing board)
  • accurate phase current sensing
  • DC current sensing (ICS not mounted)
  • possibility of overdriving VREF with an external reference voltage

さらに表示

Key Features

• Universal input mains range: 90 – 265 V_AC frequency: 50 - 60 Hz
• Output voltage/current: 12 V/1.25 A (1.65 A peak)
• Very compact size
• Standby mains consumption: lower than 30 mW at 230 V_AC
• Minimum active mode efficiency: 81.55%
• Minimum active mode at 10% load efficiency: 71.55%
• EMI: in accordance with EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Wide input voltage range: 90 V_AC to 264 V_AC
• Output voltage: 12 V
• Output current: 1.25 A
• Rated output power: 15 W
• Quasi resonant operation
• Input power standby @ 230 V_AC : < 30 mW
• Active mode efficiency: > 82%
• EMI: pre-compliance with EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Zero-power input consumption ratified as per IEC62301 Clause 4.5 (P_{IN_ZPM} < 5 mW at 230 V_AC )
• Negative output voltage easily set through the voltage divider
• Five-star energy efficiency when operating with no load (P_{IN_no_load} < 10 mW at 230 V_AC )
• Meets ErP Lot 6 Tier 2 requirements for household and office equipment
• Meets European regulation 1275/2008 regarding eco-design requirements for standby and off-mode electric power consumption for household and office equipment
• Compliant with the ErP Lot 6 Tier 2 requirements in off-mode
• Compliant with the 10% load efficiency and 4-point average active-mode efficiency targets prescribed by the European CoC ver. 5 Tier 2
• Meets IEC55022 Class B conducted EMI even with reduced EMI filter, thanks to the frequency jittering feature
• VIPer0P 800 V avalanche rugged technology and its embedded protections ensure enhanced system reliability
• RoHS compliant

さらに表示

Key Features

• High voltage rail up to 600 V
• dV/dt immunity: 50 V/ns in full temperature range
• Driver current capability: 4 A source/sink
• Comparator for fault protections
• Smart shutdown function
• Integrated bootstrap diode
• Adjustable deadtime
• Interlocking function
• Switching times 15 ns rise/fall with 1 nF load
• 3.3 V, 5 V TTL/CMOS inputs with hysteresis
• Compact and simplified layout
• Bill of material reduction
• Effective fault protection
• Flexible, easy and fast design

さらに表示

Key Features

• Universal input mains range: 85 – 265 V_AC ; frequency: 50 – 60 Hz
• Output voltage 1: 5 V / 1.2 A
• Output voltage 2: 12 V / 0.75 A
• Very compact size
• Standby mains consumption: < 40 mW at 230 V_AC
• Average efficiency: > 75%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Five-star energy efficiency for operation under no load (P_{IN_no_load} < 20 mW @ 230 V_AC )
• Meets ErP Lot 6 Tier 2 requirements for household and office equipment
• Compliant with the 10% load efficiency and 4-point average active-mode efficiency targets prescribed by the European CoC ver. 5 Tier 2
• Meets IEC55022 Class B conducted EMI even with reduced EMI filter, thanks to the frequency jittering feature
• VIPer01 800V avalanche rugged technology and embedded protections ensure enhanced system reliability
• RoHS compliant

さらに表示

Key Features

• US input range: 85 – 132 V_AC , frequency: 50 – 60 Hz
• Output voltage / current: 12 V / 0.7 A (2.5 A peak)
• Very compact size
• Standby mains consumption: lower than 25 mW at 115 V_AC
• Min. active mode efficiency: 81.14%
• Min. active mode at 10% load efficiency: 71.14%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Universal AC main input voltage range: 85 V_AC to 265 V_AC
• Output range: 5 V / 0.36 A
• Rated output power: 1.8 W
• Input power in standby at 230 V_AC : less than 18 mW
• Active mode efficiency: > 65%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Universal AC main input voltage range: 85V_AC to 265V_AC
• Output voltage: 5 V
• Output current: 1.2 A
• Rated output power: 6 W
• No load input power @230 V_AC : < 10 mW
• Active mode efficiency: > 78%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Universal input mains range: 90 – 265V_AC , frequency: 50 – 60 Hz
• Output voltage: 12 V
• Output current: 0.65 A
• Very compact size
• Stand-by mains consumption: < 20 mW at 230V_AC
• Average efficiency: > 81%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Universal AC main input voltage range: 85V_AC to 265V_AC
• Output range: 5 V / 0.85 A
• Rated output power: 4.25 W
• Input power in standby @ 230 V_AC : < 9 mW
• Active mode efficiency: > 74%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Universal AC main input voltage range: 85 to 265 V_AC
• Output range: 12 V - 0.6 A
• Rated output power: 7.2 W
• Input power in standby @ 230 V_AC : less than 18 mW
• Active mode efficiency: > 80%
• EMI: according to EN55022-Class-B
• RoHS compliant

さらに表示

Key Features

• Smart standby architecture using the zero power mode (ZPM) for capacitive touch sensing in consumer electronics applications
• Enhanced system reliability thanks to VIPer0P 800 V avalanche rugged technology and its embedded protection
• Minimized system input power consumption: less than 30 mW at 230 V_AC in ZPM
• IEC55022 Class B conducted EMI compliant, even with reduced EMI filter, thanks to the frequency jittering feature
• IEC61000-4-2 (ESD), IEC61000-4-4 (EFT) and IEC61000-4-5 (Surge) compliant
• RoHS compliant

さらに表示

Key Features

• Expansion board based on the ST25DV04K dynamic NFC/RFID tag for STM32 Nucleo
• Up to 4-Kbit memory with NDEF support
• 54 mm diameter, single layer circular antenna
• Compatible with STM32 Nucleo boards
• Equipped with Arduino™ UNO R3 connector
• Self-powered or powered through the Arduino™ UNO R3 connectors
• Three general purpose LEDs
• Scalable solution, capable of cascading multiple boards for larger systems
• Free comprehensive development firmware library and example for ST25DV04K, compatible with STM32Cube firmware
• FCC and IC verified
• RoHS compliant

さらに表示

Key Features

• Two ready-to-use printed circuit boards (PCB):
  • ST25DV_Discovery_Mboard:
  • STM32F405VGT6 LQFP100 32-bit microcontroller, with 1 Mbyte Flash memory, 192 + 4 Kbytes SRAM.
  • LCD color screen (320 x 200 pixels)
  • Touch screen driver
  • Different color LEDs (power, user, ST link)
  • User push button
  • Joystick for menu selection
  • リセットボタン
  • On board ST link for microcontroller firmware upgrade and debug
  • ST link mini USB
  • User micro USB
  • USB micro or mini connector for board powering
  • Demonstration use cases stored in memory
  • Demonstration edition (optional add-on module) with Bluetooth Low Energy module, Wi-Fi^® module and JTAG 20 pin connector
• ST25DV_Discovery_ANT_C5:
  • 40 mm x 24 mm, 13.56 MHz inductive antenna etched on the PCB
  • ST25DV04K Dynamic NFC / RFID tag
  • I² C interface connector
  • Energy harvesting output (VOUT) with a 10 nF capacitance filtering circuit
  • GPO configurable as RF WIP/BUSY output, to indicate that an RF operation is ongoing

さらに表示

Key Features

• Half-bridge configuration
• High voltage rail up to 600 V
• Includes samples of each compatible gate driver in SO8 package
  • L6385E, L6387E, L6388E, L6389E,
  • L6395, L6398, L6399
• Compatible with MOSFETs/IGBTs in
  • DPAK, D2PAK, TO-220, TO-220FP
• dV/dt transient immunity ± 50 V/ns in full temperature range
• Integrated bootstrap diode
• Dedicated high- and low-side driving inputs
• Compact and simplified layout
• Gate drivers in the kit features different functionalities and characteristics
  • UVLO on both - high-side and low-side
  • Internal deadtime, or no deadtime
  • Interlocking for anti cross-conduction protection
  • Ability to drive asymmetrical half-bridges and switched reluctance motors
  • Active high or active low LIN for single input gate driving

さらに表示

Key Features

• Two high-temperature thyristors (SCR) in D²PAK package to bypass the inrush resistor
• Compact SMD solution: 26 x 26 mm (≈ 1 sq. in)
• Simple drive circuit: 2 low voltage transistors and 7 resistors (no MCU)
• Requires an unregulated power supply (12 V typ.; created from a secondary winding)
• Compatible with PFC and fly-back converter
• Suitable for applications from 50 W up to 800 W (230 V_RMS , T_AMB  = 60 °C)
• Input voltage range: 90-265 V_AC , 50/60 Hz
• Robust and immune (2 kV IEC 61000-4-5, 2.5 kV IEC 61000-4-4) and low EMI noise (EN55014) solution
• RoHS compliant

さらに表示

Key Features

• Driver current capability: 2 A source, 2.5 A sink
• Integrated bootstrap diode
• Interlocking function
• 3.3 V, 5 V TTL/CMOS inputs with hysteresis
• UVLO on both high-side and low-side sections
• dV/dt immunity: 50 V/ns in full temperature range
• Compact and simplified layout
• Bill of material reduction
• Flexible, easy and fast design

さらに表示

Key Features

• Driver current capability: 2 A source, 2.5 A sink
• Integrated bootstrap diode
• Single input and shutdown pin
• Adjustable deadtime
• 3.3 V, 5 V TTL/CMOS inputs with hysteresis
• UVLO on both high-side and low-side sections
• dV/dt immunity: 50 V/ns in full temperature range
• Compact and simplified layout
• Bill of material reduction
• Flexible, easy and fast design

さらに表示

Key Features

• AC Main Input voltage range: 100 V_AC to 265 V_AC
• Mains frequency (f_L ): 50 Hz / 60 Hz
• Output voltage typ: 12 V
• Output current: 1.25 A
• Output ripple voltage: 50 mV
• Rated output power: 15 W
• Input power in standby @230 V_AC : 50 mW
• Active mode efficiency: 78%
• Ambient operating temperature: 60 °C
• RoHS compliant

さらに表示