-
The devices are single channel high-side drivers manufactured using ST proprietary VIPower M0-7 technology and housed in PowerSSO-16 and SO-8 packages. The devices are designed to drive 12 V automotive grounded loads through a 3 V and 5 V CMOS-compatible interface, and to provide protection and diagnostics.
The devices integrate advanced protective functions such as load current limitation, overload active management by power limitation and overtemperature shutdown with configurable latch-off.
A FaultRST pin unlatches the output in case of fault or disables the latch-off functionality.
A dedicated multifunction multiplexed analog output pin delivers sophisticated diagnostic functions including high precision proportional load current sense, supply voltage feedback and chip temperature sense, in addition to the detection of overload and short circuit to ground, short to VCC and OFF-state open-load.
A sense enable pin allows OFF-state diagnosis to be disabled during the module low-power mode as well as external sense resistor sharing among similar devices.Key Features
- AEC-Q100 qualified
- 一般
- Single channel smart high-side driver with MultiSense analog feedback
- Very low standby current
- Compatible with 3 V and 5 V CMOS outputs
- MultiSense diagnostic functions
- Multiplexed analog feedback of: load current with high precision proportional current mirror, VCC supply voltage and TCHIP device temperature
- Overload and short to ground (power limitation) indication
- Thermal shutdown indication
- OFF-state open-load detection
- Output short to VCC detection
- Sense enable/disable
- Protections
- Undervoltage shutdown
- Overvoltage clamp
- Load current limitation
- Self limiting of fast thermal transients
- Configurable latch-off on overtemperature or power limitation with dedicated fault reset pin
- Loss of ground and loss of VCC
- Reverse battery with external components
- Electrostatic discharge protection
サンプル & 購入
| 製品型番 | パッケージ | 梱包タイプ | Operating Temperature (°C) (min) | 製品ステータス | 概算価格（USS） | 数量 | ECCN (US) | Country of Origin | 販売代理店からオーダー | STからオーダー |
|---|---|---|---|---|---|---|---|---|---|---|
| VN7140ASTR | SO-8 | Tape And Reel | - |
アクティブ
|
0.4668 | 1000 | EAR99 | CHINA | 在庫チェック | 購入 |
(*) Suggested Resale Price per unit (USD) for BUDGETARY USE ONLY. For quotes, prices in local currency, please contact your local ST Sales Office or our Distributors
ビデオ
Leading-edge product portfolio for a wide range of automotive applications
Electro-thermal simulator for devices in ViPower technology
ソフトウェア製品
評価ツール
-
-
Build your ST evaluation High Side Driver Automotive system: thanks to the ST's SPC5-EV-ADIS adapter you can combine the SPC560B-DIS Discovery board along with VIPower easy boards addressing several automotive applications such as front & rear car lighting, automotive resistive, inductive and capacitive loads, automotive smart power distribution, glow plug, heating systems, relay replacement and high power resistive and inductive actuators.
A broad range of Easy Boards EV-VNx7xxx from 3mΩ to 140mΩ are available on ST.COM. Please find here below a complete list where to select the best boards fitting your application.
Solution Components
製品型番 概要 ステータス Core Products Price (US$)* Order / DownloadSPC56B-Discovery Key features
- SPC560B54L5 32-bit 48 MHz e200z0h CPU, 32-bit Power Architecture® Technology CPU, 768 kB Code Flash in an LQFP144 package.
- On-board USB-JTAG PLS debugger and HW selection mode to use stand-alone JTAG debuggers.
- Board power supply: through external +12 V PSU or from the USB bus (5 V supply voltage).
- Seven LEDs: D6 for 5 V power on,D2 for Reset, D101, D102, D103 for PLS debugger section, D7 and D8 for PC3 and PC2 outputs
- Two push buttons (reset and user)
- A potentiometers for ADC input (user)
- Two extension headers (2 x 36 pin - 100 mil) for all LQFP144 pins and for quick connection to prototyping boards, additional modules and easy probing.
- JTAG interface (2 x 7 male 100mil connector)
- USB port (mini -B)
- 16 MHz crystal
- Specification:
- Board size 100 x 65 mm
- MCU: SPC560B54L5 - LQFP144
- 2 extension headers 2 x 36 pin - 100 mil
- DC connector (+12 V input)
- Mini USB - B
- JTAG 2 x 7 - 100 mil connector
Discovery Kit for SPC56 B line - with SPC560B54L5 MCU アクティブ85.75 購入 SPC5-EV-ADIS Key features
- Board size 100 x 55 mm
- Two extension headers (2 x 36 pin - 100 mil) for quick connection to SPC560B-DIS discovery board
- Extension headers for quick connection of M0-7 easy board
- Extension headers for quick connection of H-Bridge easy board
- Controllable by dedicated GUI for HSD or for H-Bridge available on www.st.com
- Free ready to run application firmware for HSD or for H-Bridge available on www.st.com, to support quick evaluation and development
Adapter board アクティブ32.12 購入 EV-VN7140AS VN7140AS Evaluation Board アクティブVN7140ASTR 3.92 STSW-SPC5EV-ADIS SPC5-EV-ADIS Graphical User Interface for M0-7 High Side Drivers アクティブ- 製品型番 サプライヤ ダウンロード STSW-SPC5EV-ADIS ST EV-VN7140AS説明 :
VN7140AS Evaluation BoardPrice (US$)*
3.92STSW-SPC5EV-ADIS説明 :
SPC5-EV-ADIS Graphical User Interface for M0-7 High Side DriversPrice (US$)*
-製品型番 サプライヤ ダウンロード STSW-SPC5EV-ADIS ST
-
| 製品型番 | 製品ステータス | パッケージ | グレード | RoHSコンプライアンスグレード | Material Declaration** |
|---|---|---|---|---|---|
| VN7140ASTR |
アクティブ
|
SO-8 | オートモーティブ | Ecopack2 |
(**) The Material Declaration forms available on st.com may be generic documents based on the most commonly used package within a package family. For this reason, they may not be 100% accurate for a specific device. Please contact our sales support for information on specific devices.
