製品概要
概要
The VND830AEP-E is a monolithic device made using| STMicroelectronics VIPower M0-3 Technology. The VND830AEP-E is intended for driving any type of multiple load with one side connected to ground.
The Active VCC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table).
This device has two channels in high side configuration; each channel has an analog sense output on which the sensing current is proportional (according to a known ratio) to the corresponding load current. Built-in thermal shutdown and outputs current limitation protect the chip from over temperature and short circuit.
The device automatically turns off in the case where the ground pin becomes disconnected.
-
特徴
- Reverse battery protection
- Protection against loss of ground and loss of VCC
- In compliance with the 2002/95/EC european directive
- Current limitation
- Thermal shutdown
- DC short circuit current: 6A
- Proportional load current sense
- CMOS compatible inputs
- Overvoltage clamp
- Very low standby power dissipation
- Undervoltage and overvoltage shutdown
EDAシンボル / フットプリント / 3Dモデル
STマイクロエレクトロニクス - VND830AEP-E
Speed up your design by downloading all the EDA symbols, footprints and 3D models for your application. You have access to a large number of CAD formats to fit with your design toolchain.
Please select one model supplier :
EDAシンボル
フットプリント
3Dモデル