This firmware is a starting point for the development of a metrology application using the STPM32 ASSP for metering applications, and an STM32 microcontroller. It has been implemented for the STEVAL-IPE023V1 USB interface board for the STPM series of energy meter ASSPs, interfaced with the EVALSTPM32 single-phase energy metering evaluation board, but can easily be ported across different MCU families.
The firmware provides the basic functions to initialize, read and write to the STPM32 metrology ASSP through an SPI or UART interface, as well as a basic metrology application based on a microcontroller timer. The firmware uses the IAR toolchain.
- Initialization of STM32 MCU
- Reset sequence of the STPM32 ASSP
- Communication through UART or SPI interface
- Block transfer in read and write mode
- Data latch through SYN pin of STPM32 ASSP
- Basic metrology application example based on STM32 MCU timer to read energy and voltage
- Easy portability across different MCU families
Something went wrong with the server request. Please try again in a few moments.
Request for software successfully submitted. The approval process may take up to 48 hours. After you have been approved, you should receive a link to the requested software via email.
Unfortunately, the link you clicked didn't work. Don't worry, here are the steps you can take to get your download started:If you still can't download the software, please reach out to us on the ST Community and we will help you
- Ensure you are using the same browser used to made the initial request
- Check that cookies are allowed in your browser
- Update your browser to its latest version
- Please also note that links forwarded by somebody else will not work