電源システム

主な特徴

• Mounted Engineering Model RHF1201K1: Rad-hard, 50 Msps, 12-bit analog-to-digital converter (see RHF1201 datasheet for further information)
• Mounted components (ready-to-use)
• Material: two-layered FR-4
• PCB thickness: 1.6 mm
• Copper thickness: 35 μm
• Analog connections: SMA
• Digital connections: IDC34
• Supply connections: banana 2 mm

さらに表示

主な特徴

• Mounted Engineering Model RHF1401K1: Rad-hard, 30 Msps,14-bit analog-to-digital converter (see RHF1401 datasheet for further information)
• Mounted components (ready-to-use)
• Material: two-layered FR-4
• PCB thickness: 1.6 mm
• Copper thickness: 35 μm
• Analog connections: SMA
• Digital connections: IDC34
• Supply connections: banana 2 mm

さらに表示

主な特徴

• Designed for Flat-10 package
• Used to perform on-board characterization of the RHF100 prior to integration of STMicroelectronics' products
• Resistor and capacitor footprints implemented for 0805 series
• Two decoupling capacitors implemented on power supply pin and output pin to benefit from maximum performance of ST products
• R3 (cathode) resistor set to 18 kΩ, with a power supply voltage of 3.3 V this gives a cathode current of about 110 μA
• If RHF100 device is soldered onto the EVAL-RHF100, R1, R2, and Cn1 are not fitted onto the PCB

さらに表示

主な特徴

• Designed for Flat-10 package
• Used to perform on-board characterization of the RHF1009A prior to integration of STMicroelectronics' products
• Resistor and capacitor footprints implemented for 0805 series
• Two decoupling capacitors implemented on power supply pin and output pin to benefit from maximum performance of ST products
• R3 (cathode) resistor set to 6.8 kΩ, with a power supply voltage of 3.3 V this gives a cathode current of about 110 μA
• If RHF1009A device is soldered onto the EVAL-RHF1009A, Cn1 is fitted onto the PCB and shorted to get an output voltage of 2.5 V. If a different output voltage than 2.5 V to 5.5 V is needed, remove the jumper located on Cn1 and place the adequate value of R1, R2, and R3

さらに表示