カー･オーディオ用システム電源  

ST provides a large selection of Power Management ICs and System Basis Chips (SBC) specifically conceived to fit into automotive infotainment systems, clusters, USB hubs, electronic control units (ECU), and gateways as well as car body and door zone modules.

They combine several power management building blocks, like linear and switching voltage regulators and high-side switches in the same package, with an extensive set of diagnostic and protection features, including short-circuit and overvoltage, with a dedicated control bus (I2C for multichannel ICs and SPI for SBCs) and physical LIN and CAN transceivers where needed.

Multichannel power management ICs satisfy current applications where many functions are concentrated in small places and complex processors as well as surrounding components increase their demand on power rails and current absorption. Here, other features including rail sequencing, voltage monitors and basic diagnostics are often mandatory. The new product family of multiple voltage regulators easily supports the growing demand for UBS power management devices.

Smart power management and system basis ICs are pervading more and more the automotive market, finding applications in ECUs, body modules, and gateways. The high versatility of these products allows for simple use in body modules to supply and drive loads and microcontrollers as well as establishing a reliable interface through dedicated communication protocols. ST offers a broad selection of features and characteristics including, for instance, a very low quiescent current and fail-safe functionality.

Manufactured with ST’s mixed signal power technologies, they meet and exceed quality and reliability requirements for vehicle on-board electronics.

• L99PM62GXP
  Power Management IC with LIN and high speed CAN
• L5956
  Voltage regulator with ignition comparator, reset, overcurrent protection and 3.3V regulator with independent enable
• L4954
  Voltage regulator with backup and reset, overvoltage protection and low voltage warning
• L99PM62XP
  Power management IC with LIN and high speed CAN
• L9396
  Multiple Power Supply for Automotive Applications
• L5950
  Voltage regulator with I2C bus, very low stand-by current and low spread output voltage
• L9952GXP
  Power management system IC
• L4953G
  Voltage regulator with backup and reset, ignition comparator and low voltage warning
• L5963
  Dual monolithic switching regulator with LDO and HSD
• L5957
  Voltage regulator with ignition comparator, reset, overcurrent protection, 5V regulator (CAN) with independent enable
• L99PM72GXP
  Advanced power management system IC with embedded LIN and high speed CAN transceiver supporting CAN Partial Networking
• L5964
  Monolithic dual 3.5 A step-down switching regulator with LDO
• L5962
  Voltage regulator with DC-DC plus switchable linear regulators controlled by I²C bus
• L5965
  Multiple power management for automotive vision and radar systems
• L5958
  Switchable linear voltage regulators with reset and battery voltage warning
• L5959
  Voltage regulator with very low stand-by current, reset, hold, backup, under/over voltage detection, overcurrent limitation
• L99PM60J
  Power Management IC with LIN transceiver
• L9758
  Multiple supply for engine control
• L99PM72PXP
  Advanced power management IC, with embedded LIN and HS CAN transceiver, supporting CAN Partial Networking