Wi-Fi Connected Nodes

Key Features

• STM32F413ZHT6 microcontroller featuring 1.5 Mbytes of Flash memory and 320 Kbytes of SRAM, in LQFP144 package
• On-board ST-LINK/V2-1 supporting USB re-enumeration capability
• USB ST-LINK functions:
  • Virtual COM port
  • Mass storage
  • Debug port
• 240x240-pixel LCD with parallel interface and touch-panel connector
• 8-Mbit PSRAM; 512K word x 16bits
• 128-Mbit Quad-SPI Flash memory
• I² S audio codec
• Jack connector for Audio line with microphone input and stereo output
• Two on-board ST-MEMS microphones
• Connector extension for up to 5-MEMS microphones.
• USB OTG FS with Micro-AB connector
• Connector for microSD^™ card
• Integrated Wi-Fi^® module 802.11 b/g/n
• Two push-buttons (user and reset)
• Two user LEDs: one green and one red
• Arduino^™ Uno V3 connectors
• Four power supply options:
  • ST LINK/V2-1
  • USB FS connector
  • 5 V from Arduino^™ Uno V3
  • USB charger
• Comprehensive free software including a variety of examples, part of the STM32Cube package
• Support of a wide choice of integrated development environments

Show More

Key Features

• Two ready-to-use printed circuit boards (PCB):
  • ST25DV_Discovery_Mboard:
  • STM32F405VGT6 LQFP100 32-bit microcontroller, with 1 Mbyte Flash memory, 192 + 4 Kbytes SRAM.
  • LCD color screen (320 x 200 pixels)
  • Touch screen driver
  • Different color LEDs (power, user, ST link)
  • User push button
  • Joystick for menu selection
  • Reset button
  • On board ST link for microcontroller firmware upgrade and debug
  • ST link mini USB
  • User micro USB
  • USB micro or mini connector for board powering
  • Demonstration use cases stored in memory
  • Demonstration edition (optional add-on module) with Bluetooth Low Energy module, Wi-Fi^® module and JTAG 20 pin connector
• ST25DV_Discovery_ANT_C5:
  • 40 mm x 24 mm, 13.56 MHz inductive antenna etched on the PCB
  • ST25DV04K Dynamic NFC / RFID tag
  • I² C interface connector
  • Energy harvesting output (VOUT) with a 10 nF capacitance filtering circuit
  • GPO configurable as RF WIP/BUSY output, to indicate that an RF operation is ongoing

Show More

Key Features

• Ultra-low-power STM32L4 Series MCUs based on Arm^® Cortex^® -M4 core with 1 Mbyte of Flash memory and 128 Kbytes of SRAM, in LQFP100 package
• 64-Mbit Quad-SPI (Macronix) Flash memory
• Bluetooth^® V4.1 module (SPBTLE-RF)
• Sub-GHz (868 MHz or 915 MHz) low-power-programmable RF module (SPSGRF-868 or SPSGRF-915)
• 802.11 b/g/n compliant Wi-Fi^® module from Inventek Systems (ISM43362-M3G-L44)
• Dynamic NFC tag based on M24SR with its printed NFC antenna
• 2 digital omnidirectional microphones (MP34DT01)
• Capacitive digital sensor for relative humidity and temperature (HTS221)
• High-performance 3-axis magnetometer (LIS3MDL)
• 3D accelerometer and 3D gyroscope (LSM6DSL)
• 260-1260 hPa absolute digital output barometer (LPS22HB)
• Time-of-Flight and gesture-detection sensor (VL53L0X)
• 2 push-buttons (user and reset)
• USB OTG FS with Micro-AB connector
• Expansion connectors:
  • Arduino™ Uno V3
  • PMOD
• Flexible power-supply options:
  • ST LINK USB V_BUS or external sources
• On-board ST-LINK/V2-1 debugger/programmer with USB re-enumeration capability: mass storage, Virtual COM port and debug port
• Comprehensive free software HAL library including a variety of examples, as part of the STM32Cube MCU Package
• Support of a wide choice of Integrated Development Environments (IDEs) including IAR^™ , Keil^® , GCC-based IDEs, Arm^® Mbed Enabled^™
• Arm^® Mbed^™ online (see http://mbed.org)

Show More

Key Features

• Wi-Fi adapter for STWIN (STEVAL-STWINKT1)
• Plugs into STWIN core system board through dedicated 12-pin connector
• Single 3.3 V power supply input
• ISM43362-M3G-L44-E Wi-Fi module:
  • 802.11 b/g/n Compatible based on Broadcom MAC/Baseband/Radio device
  • Fully contained TCP/IP stack
  • Host interface: SPI up to 25 MHz
  • Network features ICMP ( Ping), ARP, DHCP,TCP, UDP
  • Low power operation (3.3 V supply) with built-in low power modes
  • Secure Wi-Fi authentication WEP-128, WPA-PSK (TKIP), WPA2-PSK
  • CE certified
  • FCC certified
  • IC certified
• RoHS and China RoHS compliant
• WEEE compliant

Show More